- #Does a smart converter charge and power at the same time how to#
- #Does a smart converter charge and power at the same time install#
#Does a smart converter charge and power at the same time how to#
How to achieve all this? Well, the devil's in the details. If you see something like INPUT AC 120/240 V 5060 Hz 1300 W, then your device is dual-voltage, and you can safely use it for voltages.
Do not expose the GP Smart Charger to rain, snow, spray, bilge, or dust. If you want to use it elsewhere, you’ll need a converter.
#Does a smart converter charge and power at the same time install#
: Before you install and use your Go Power Smart Converter/Charger. You should only worry that the current being used by a load is lower than the current coming to the battery from the charger connected to the solar panel. WARNING: Before you install and use your Go Power Smart Converter/Charger, be sure to read these safety instruc-tions. As a power supply, it allows the user to operate any 12 V nominal DC load up to the converter’s rated output current. When its own voltage is higher, it will be losing charge. Smart Converter Charger (GPC) series power converter/ charger converts 120 V nominal AC to 14.6/13.6/13.2 V DC. When the voltage applied to it is higher than its own, it will be accepting charge. What it "cares" about is the voltage across its terminals. The main issue here would be the charger's ability to limit its current so it doesn't burn under too much load.Ī battery doesn't really know and care about being charged and used at the same time. Both of those scenarios are worse for the batter, and that's why it is better to actually keep charging it while using it. The problem is that no battery manufacturers tell us to charge a battery for 80-150 hours to achieve a full charge.
However, a battery's type and capacity should be taken into account along with the charging current and the load current, but generally speaking a battery without a load can get overcharged, while a battery disconnected from a charger and connected to a load gets discharged sooner and can get too low. Both systems monitor the battery banks State of Charge and supply power to the batteries as needed. Using the shore line provides you 115VAC for everything in your RV, including the converter the converter, converts the 115VAC to 12VDC and charges your house batteries the 12 VDC coming from your batteries will give you 12 VOLTS to operate your inside lights, furnace, hoer, water pump, ceiling fans and probably your fridge, if it is a 3 way fridge. Both are systems used to charge the batteries and are designed to be compatible with each other, so there is no need to turn off the solar when shore power is plugged in. You can use it and charge it at the same time, it shouldn't damage it. Yes, shore power and solar panels can be used at the same time. You shouldn't cut off the charge to the battery when you're using it, because you're discharging it while your available power from the solar panel is sitting idle, doing nothing, and it would be better to use it for the load.
0 kommentar(er)
